Dear Colleagues We are about to receive a new environmental chamber and that means our old Espec PRA-2GP (circa 1991) has found itself homeless. A heart breaking story I know.
We would be willing to give this unit to somebody who will provide it a decent shelter but there is a condition. To qualify you must be a small company who could use this equipment to help develop your products. This is not for somebody to treat as a windfall just to take it and then just sell it off. Please respect that request, and do not try to acquire the unit unless you qualify. The company taking this unit will be responsible for removing the unit from our premises. We are located near Toronto Canada. About the unit: It is an 8 cu ft model floor standing model 92 cm W by 90 cm deep by 205 cm high (on casters) I would hazard a guess that is it at least 300 kg but that is just a WAG It only runs temperature (the humidity section actually runs too, but if you do, you will find that the stainless steel inner liner has failed and water >from the humidity system leaks like a sieve internally into the chamber's insulation and onto the floor so that should be fair warning) This unit power requirements are 208V 60 Hz 3 phase (or remove the fancy add on transformer sitting on top and it would be a 230V 60HZ single phase unit) Disclaimer Who we give this chamber to is our decision alone and any and all request(s) for this unit need not be accepted by us. To enquire further, please email the undersigned offline Kind Regards, Kevin Harris Manager, Approvals Group Digital Security Controls 3301 Langstaff Road Concord, Ontario CANADA L4K 4L2 Tel: +1 905 760 3000 Ext. 2378 Fax +1 905 760 3020 Email: [email protected] This transmission is intended to be delivered only to the named addressee(s) and may contain information that is confidential or proprietary. If this information is received by anyone other than the named addressee(s), the recipient(s) should immediately notify the sender by e-mail or by telephone at 905-760-3000 and delete this message. In no event shall this material be read, used, copied, reproduced, stored or retained by anyone other than the named addressee(s), except with the express written consent of the sender. Thank you. ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/listserv/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Mcantwell [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
