Greetings fellow Group Members, We are preparing to construct a new OATS and I am in the middle of generating my requirements document.
I was wondering if any of you have any practical solutions to the flush mounted AC mains receptacles - directly coupled to the horizontal ground plane. Of course, the issue is the rotation of the turntable and the twisting of the cables. I would like to keep the center hole of the turntable open if possible to allow pass-through for connection of cables to remotely located devices [i.e. ANSI C63.4 6.1.2.1]. Also, with regards to EN 55022, there is a statement that AMNs, if used, shall be installed under the ground plane for radiated measurements. Does anyone have any feedback on this practice, especially with regards to equipment with multiple power connections? Best Regards, Mac Elliott EMC Engineer Tyco Safety Products / Sensormatic 6600 Congress Avenue Boca Raton, FL 33487 (561)-912-6462 [email protected] ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/listserv/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
