Hi experts, I wonder if some one has a link or a good advise for where i can get hold on specific requirements for machinery exported to USA/Canada. Of course there are some points in the relevant standards for the equipment, but are there additional rules that apply for contents ? Especially i would like to know, is it OK to make a general product safety manual covering several different products ? One chapter with general safety issues applicable for all products, and after that product specific safety instructions in seperate chapters ? I.e. can we mix information that are not needed with information needed as long as the sections are clealy identifyable for a particular product ?` Hope this gives some kind of meaning.. Best regards Peter
______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________ - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
