Don,
I can put together a differential E-field probe for you that’s good to 100 kHz or so. Our Linear Technology LT1167 amp should be good for that. I’m thinking the probes can be 1 cm square plates spaced 1 cm. Is that small enough – can you go bigger? What field strengths are you looking to measure? Dave Cuthbert Linear Technology _____ From: [email protected] [mailto:[email protected]] On Behalf Of Umbdenstock, Don Sent: Friday, October 05, 2007 2:52 PM To: [email protected] Subject: E-Field Probes I would like to measure directly a pulsed E fields down to 10 kHz. I am looking for probes (or other suggestion) that can measure a 1 ms, 10 % duty cycle pulsed signal as low as 10 kHz. I found some at ETS Lindgren, but a probe that will do 10 kHz has a response time of 40 ms (would miss the signal); another has a <1ms response time but has a lower limit of 100 kHz. Anyone know of any products that can perform the measurement described above? Any suggestions? Thanks in advance, Don Umbdenstock Manager Compliance Engineering Tyco Safety Products / Sensormatic 6600 Congress Avenue Boca Raton, FL 33487 USA Phone: 561.912.6440 <mailto:[email protected]> [email protected] ______________________________________________________________________ This e-mail has been scanned by MCI Managed Email Content Service, using Skeptic(tm) technology powered by MessageLabs. For more information on MCI's Managed Email Content Service, visit http://www.mci.com. ______________________________________________________________________ - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. Website: http://www.ieee-pses.org/ To post a message to the list, send your e-mail to [email protected] Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas [email protected] Mike Cantwell [email protected] For policy questions, send mail to: Jim Bacher: [email protected] David Heald: [email protected] All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
