Nick Note 129 on Page 44 of "The Blue Book" states:
According to the Directives relating to machinery, personal protective equipment, active implantable medical devices, medical devices, potentially explosives atmospheres, lifts (as regards safety components), in vitro diagnostic medical devices, and radio and telecommunications terminal equipment the minimum dimension of the CE marking may be waived for small devices. I haven't checked all the other directives, but R&TTE Annex VII: 2) The CE marking must have a height of at least 5 mm except where this is not possible on account of the nature of the apparatus. regards Charlie On Nov 24, 2009, Nick Williams <[email protected]> wrote: Most (if not all) of the CE marking directives say that the minimum size for the CE logo should be 5mm but I have it in my mind that somewhere there is a guidance or additional wording which states that if the maximum dimension of the product is less than 150mm then the logo can be reduced to 3mm. This will either be in one of the Directives, or in a standard, or in a guidance document but I'm struggling to put my finger on it now I need to know in a hurry, of course. Can anyone quickly point me to where this notion could have come from? Nick. - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc Graphics (in well-used formats), large files, etc. can be posted to that URL. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]> - This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at http://www.ieeecommunities.org/emc-pstc Graphics (in well-used formats), large files, etc. can be posted to that URL. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher <[email protected]> David Heald <[email protected]>
