Scott, Australia require the energy efficiency rating (i.e. IV or V) be marked on an external power supply for a couple of years now.
Best regards, Kevin Richardson Stanimore Pty Limited Compliance Advice & Solutions for Technology (Legislation/Regulations/Standards/Australian Agent Services) Ph: 02-4329-4070 (Int'l: +61-2-4329-4070) Fax: 02-4328-5639 (Int'l: +61-2-4328-5639) Mobile: 04-1224-1620 (Int'l: +61-4-1224-1620) Email: [email protected] or [email protected] URL: www.stanimore.com Confidentiality This material (this email including all attachments) may contain confidential and/or privileged information intended to be read or used by the addressees only. If you are not one of the intended recipients or you have received this material in error, any copying, disclosure, distribution, use of or reliance upon this material is prohibited. Please immediately notify Stanimore Pty Limited and delete/destroy all copies (electronic and hardcopy) of this email and all attachments. While the sender tries to ensure the accuracy of the information contained in this material, Stanimore take no responsibility for any actions taken as a result of receiving this material or for any consequence of its use. -----Original Message----- From: Scott Douglas [mailto:[email protected]] Sent: Tuesday, 12 February 2013 2:23 PM To: [email protected] Subject: [PSES] EuP Questions Fellow List Persons... I think I know the answer to these two questions, but would appreciate a confirmation from the group. 1. If a A/V or ITE product in full operation consumes less than 0.5W, and the EPS that supplies this product consumes less than 0.3 W no load with efficiency above the calculated requirement, does this product need to meet EuP for CE market? Or do you claim compliance or exemption from that requirement? 2. Is there any legal requirement anywhere in the world where the energy efficiency number (Roman numerals IV or V) shall be marked on an EPS (external power supply)? Thank you in advance for any and all comments. Best, Scott Douglas - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieee-pses.org/emc-pstc.html Attachments are not permitted but the IEEE PSES Online Communities site at http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used formats), large files, etc. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]> - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieee-pses.org/emc-pstc.html Attachments are not permitted but the IEEE PSES Online Communities site at http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used formats), large files, etc. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]>
