Dear Experts, One customer is designing own connector for hot-plug application (power supply). Question is how much longer shall be PE pin than supply pins. Which standard shall be used for such connector?
For reference you can see similar connector on below link. http://www.harting.com/en/service/catalogues/downloads-and-order-connectivity-networks/din-41612-connectors/ I have checked UL 1977 and there is no such requirement. Somewhere I found a note that applicable standard is IEC 60603-2 however I am not sure if requirement for dimension of PE pin is included. I am surprised that no such requirement exist in IEC 60950-1 or IEC 62368-1. They just mention in clause 2.6.5.4 that PE connection shall make earlier and brake later than the supply connections. Any idea? Thank you for your support. Best regards, Bostjan - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieee-pses.org/emc-pstc.html Attachments are not permitted but the IEEE PSES Online Communities site at http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used formats), large files, etc. Website: http://www.ieee-pses.org/ Instructions: http://www.ieee-pses.org/list.html (including how to unsubscribe) List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]>
