Hello Jeff I don’t understand about how I can tune-up my motor if I can’t see wave diagram that suppose to be generated by the signals:
Siggen1.cosine
Siggen1sine
Siggen1.square
Siggen1triangle
Srepgen1connect
I don’t have that signals, so what I have to do?
All description in manual based on if I have that particular signals (siggen,
cosin …) and I don’t.
Am I right?
Are there other direction or manual that describes tune-up based on my
situation?
I confused.
Please let me know what should I do.
Thanks
aramk
-----Original Message-----
From: [EMAIL PROTECTED] on behalf of Jeff Epler
Sent: Wed 11/29/2006 5:29 AM
To: Enhanced Machine Controller (EMC)
Cc:
Subject: Re: [Emc-users] Problem with Hal Scope use
The signals, pins, and parameters available are the ones created by the
running HAL components. This is the expected behavior.
Jeff
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share
your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
<<winmail.dat>>
------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys - and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
