This problem is being solved by increasing the jitter tolerance from +-5% to +-10%, it will be in the next release of EMC.
(see my ~20-mails long conversation on this topic in emc-developers) The message is only a warning, not a catastrophic error, no need to be scared... On 12/29/06, Kirk <[EMAIL PROTECTED]> wrote: > I have EMC2 running on a three axis Mill. It runs great however > whenever I start up the HMI program an error is reported. It says that > I should check dmeg. I have included a copy of the dmesg output. I'm > sure I need to change the configuration of RTAI but I don't have the > slightest idea of what to change. Could anyone please help? > > Thanks, > > Kirk > > > > ------------------------------------------------------------------------- > Take Surveys. Earn Cash. Influence the Future of IT > Join SourceForge.net's Techsay panel and you'll get the chance to share your > opinions on IT & business topics through brief surveys - and earn cash > http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys - and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users