Andy Holcomb wrote: > Okay, I have tried all of the values I get from the lspci command and > non of them work; but, the factory port at 378 does work. > > the values I got were > dc00 > d800 > d400 > d000 > cc00 > c800 > > From what I remember on emc1 I had to use d000 > > Andy > > > > Chris Radek wrote: >> On Wed, Mar 28, 2007 at 12:59:17PM -0500, Andy Holcomb wrote: >>> Remind me again how to find the address of the lpt ports. >>> Where do I make this change of address? >> http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?NetMos >> >>
I was doing a bit of research and noticed a couple things. First, if one is searching for something as mentioned in the wiki page above you could use lspci -v | grep searchstring -A num ... searchstring being the actual string one is looking for and num being the number of lines following the string once it is located. Second, I admit I don't have one of these cards yet, but I was curious as to how the port was experimented with. Did the person just hook up to the parallel port and change the I/O port number until they got a reaction at the output of the port? Kyle ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
