Gene Heskett wrote: > On Wednesday 28 March 2007, Alex Joni wrote: >> http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TweakingSoftwareStepGenerati >> on >> > Its not responding. > >> Regards, >> Alex >> >> ----- Original Message ----- >> From: "Andy Holcomb" <[EMAIL PROTECTED]> >> To: "Enhanced Machine Controller (EMC)" >> <[email protected]> >> Sent: Wednesday, March 28, 2007 11:11 PM >> Subject: [Emc-users] Axis speed slower on Emc2 than Emc1 >> >>> On EMC1, I was running Axis speeds of more than 120ipm, I can't get >>> EMC >>> 2 past around 60. I am running a 1.6 ghz computer. I don't know how >>> much memory, will memory cause this or is it the computer? >>> >>> Andy
I did notice that between Gene's reply and Alex's reply the 'on' at the end of the line broke out of the link. What I am saying is make sure it says: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TweakingSoftwareStepGeneration and not: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TweakingSoftwareStepGenerati on Kyle ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
