Sam Sokolik wrote: > I think there is an encoder module within emc that allows a single channel > encoder+index.. I know of one person using it on their lathe for threading.
Yes, there is a SOFTWARE based module that can count a single channel "encoder". If your spindle speed times encoder PPR is low enough to be counted in software, that will work fine. If you need hardware based counting because you have a high speed spindle and a high PPR encoder, then you will need a hardware solution to convert the single channel into something Jon's board can count. Regards, John Kasunich ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
