Thanks Brian. Since none of the manufacturers seem to agree on codes, it doesn't matter what they are. I was hoping that there could be some standardization, but there just isn't any. I suppose I could just use the old HNC codes:
Stock Feed M20 Collet Open/Close M21/22 Cut-Off Extend M23 Cut-Off + Part Chute Extend M24 CO + PC Retract M25 High Range Forward M43 High Range Reverse M44 but it's not really an HNC any more. Are any of these already reserved in EMC? On Fri, 2007-08-31 at 20:58 -0700, Brian Pitt wrote: > On Friday 31 August 2007 19:10, Kirk Wallace wrote: > > Does anyone have an opinion on which g-codes to assign to these lathe > > functions? > > Collet Closer Open ... snip > ours is set up to call one macro to feed stock and branch to another to load > a new bar ,feed out a > little extra stock and part off the chamfered end > > Brian ------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
