Sven,
What servo controller board are you using?
Reg
On 9/8/07, Svenne Larsson <[EMAIL PROTECTED]> wrote:
>
> I think I have the same, or at least a very similare model from Minertia.
> They are not mounted on a machine yet (will be very soon) but there
> shouldn't be any problem.
>
> Regards,
> Sven
>
> 2007/9/8, John Crane <[EMAIL PROTECTED]>:
> >
> > Has anyone ever connected EMC to Yaskawa servos? I have a 4 axis
> > machine that was designed as a laser solder machine some 15 years ago. The
> > servos are a brush type Minertia Motor # UGRMEM-02MAKOE with UTOPI-04OMX
> > optical encoder (400 pulses/rev). The controller is FR01RB7-R2M.
> > Any info would be appreciated.
> >
> >
> > Reg
> >
> >
> > -------------------------------------------------------------------------
> > This SF.net email is sponsored by: Microsoft
> > Defy all challenges. Microsoft(R) Visual Studio 2005.
> > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> > _______________________________________________
> > Emc-users mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/emc-users
> >
> >
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
