Hello,
I also have a 4 axis hot wire cnc machine, and i have
the same problem as Ryan. I successfully set the
machine to xyza axes and it works fine, but I would
rudder have the correct setup xyuv. I set the .ini
files as described here, but i still get some errors.
What version/release of EMC Ryan had? There was a
discussion at emc mirc channel, that emc release 1.7
doesn't support xyuv setup and emc release 2.x (which
can be downloaded from cvs) will.
Regards
Klemen
____________________________________________________________________________________
Tonight's top picks. What will you watch tonight? Preview the hottest shows on
Yahoo! TV.
http://tv.yahoo.com/
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
