Stainless or nylon? Makes difference, you see...
2007/11/26, [EMAIL PROTECTED] <[EMAIL PROTECTED]>:
>
> I need to
> 1) cut very fine threads on largish diameter tubes. (about 6" diameter
> pipe/tubing. Inside and outside thread.).
> 2) Cut fine threads on small diameter tubes. (sherline or Taig probably
> will do)
>
> If someone have experience with theis, please advice as to the best
> affordable machines for the two tasks.
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
