Mark
At 04:48 AM 12/18/2007, you wrote:
Guys,
For all of you that not hang around at cnczone.com, there is now some positive feedback about Keling and EMC at http://www.cnczone.com/forums/showthread.php?p=373160.
Here's one of the posts:
Keling KL-4030 + EMC2
I just finished my JGRO using a Keling kit with the KL-4030 drivers.
After some experimentation I found these EMC2 settings work with the Keling drivers:
STEPLEN >15000ns
STEPSPACE >15000ns
DIRSETUP >15000ns
DIRHOLD >15000ns
This was on an Athlon 3700+, when I switched to an older Athlon 1000 it seem to run smoother when I increased all four settings to 20,000ns. I tried reducing each setting and combination of settings below 15000ns but I could not get stable operation.
Have run several 10000+ line g-code files and am very pleased with the EMC2 + Keling combination.
Now I just have to solve some resonace issues so I can get my cutting speed up.
Regards,
Sven
2007/12/1, Mark Wendt (Contractor) < [EMAIL PROTECTED]>:
-------------------------------------------------------------------------
- Seth,
- I was poking around cnczone right after I posted the question and saw your post over there. Trying to talk Santa into getting me the package for Christmas... ;-)
- Mark
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
