On Wed, 2008-01-23 at 14:08 -0500, [EMAIL PROTECTED] wrote: > Hope posting this does not offend anyone, but here is the .hal file edited. > I commented out the old mode 0 lines and added in the mode 2 lines based on > my interpretation of the section 7 HAL documentation. Is there some other > file that I need to change or are all my troubles in these changes? > > I have marked in bold type the changes > > Thanks, Jim C > > ------------------- .HAL ------------------------------ > > # Generated by stepconf at Sun Jan 20 16:30:40 2008 > # If you make changes to this file, they will be > # overwritten when you run stepconf again > loadrt trivkins ... snip
You are beyond my stepper experience now, but what you have looks okay to me. There might be a coma where a period should be, a capital for a lower case or something like that. The error screen near the bottom might have something similar to: ... Debug file Information: your_hal_file.hal:XX pin 'pin_something_or_other' does not exsist ... The XX should be the line number in the .hal file. Other than that, a real stepper person may need to help you. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
