Bob, Check the Integrators Manual in the .ini section, [DISPLAY] section, page 24 of 193. INPUT_FILE = ........
Noel Rodes 'Roguish' -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bob Freeman Sent: Monday, February 11, 2008 10:53 AM To: [email protected] Subject: [Emc-users] axis logo module that emc loads on default Hello, All, Rather than continue the font thread for my question, I'll just ask another question. On starting EMC2 with AXIS, the axis logo gcode is loaded, apparently by default. I looked in the ini and related setup files but have not found a way to have AXIS load the default file that "I" want; is there a way to change the default file loaded by AXIS at startup? BTW, its not that I dislike the axis logo, it just generates an error when used in the TWO axis system I'm working with for my antenna measurements. The file apparently wants some Z-axis setup. Of course, I could change the default file, or link to something else, or.... Thanks, and thanks for EMC2--it just works! Regards, Bob Freeman ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.516 / Virus Database: 269.20.2/1270 - Release Date: 2/10/2008 12:21 PM No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.516 / Virus Database: 269.20.2/1270 - Release Date: 2/10/2008 12:21 PM ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
