> Stuart Stevenson wrote:
> > Gentlemen,
> > Two steps forward, one step back. The Y axis locked up while
> > moving up and down. It is progress. If we hadn't been moving it we
> > wouldn't have locked it up. All the lube was running. We will figure
> > it out. After 5 years or so of sitting it will need a little
> > attention. All is good.
> Ah, yes, you think you are chasing electronic/software problems,
> and suddenly the real HARDware has a problem! Hopefully there
> isn't any damage to ballscrews, etc.
>
> Jon
>
>
Gentlemen,
It was the Y axis brake. When the main power was turned on the
brake was released. When I turned the control on the brake was set. I
moved the leads to the brake from the NC contact to the NO contact and
voila - easy movement. WHEW!!!
thanks
Stuart
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
