CRPE Solutions wrote: > I am planning to build a router and use Linux EMC software. > > What about the compatibility of EMC with Hobbycnc.com driver boards? > > Carlos R. Pena > Santo Domingo, Dominican Republic > Two minutes on their website finds this:
"Step and Direction Control." "Works with Step and Direction software such as DeskNC, TurboCNC, Mach2, etc" EMC2 supports step and direction, so yes, it will work. Their parport connector pinout appears a few lines farther down the page. If you've read the EMC docs you already know that HAL allows you to configure any parport pinout you need. Regards, John Kasunich ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
