Just issue a g92 x0 y0 z0 when the table is were you want it this sets it the axis to 0
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of rtwas Sent: Sunday, March 16, 2008 7:30 PM To: [email protected] Subject: [Emc-users] manually setting "home" values (newb question) Hello, I'm new to cnc. I've been doing a lot of reading and experimenting with emc2. I currently would like to know how to *manually* set the home position (as apposed to *going* to the *current* home position). I have looked and looked and can't figure it out. The best I can do now is move the table to the desired position and kill emc2 and restart it. Thanks. Robert W. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
