On Mon, 2008-03-31 at 08:09 -0400, [EMAIL PROTECTED] wrote:
> You have to reference the signal with it's counterpart.  The signal should
> have two pins, a plus and minus.  A comparator would work to convert the
> signal to a single ended (referenced to ground) signal.
> 
> or use a RS-422 transeiver chip (ST490AB).
> 
> Jim C

Something like this?

http://www.wallacecompany.com/machine_shop/RS422-1a.jpg

-- 
Kirk Wallace (California, USA
http://www.wallacecompany.com/machine_shop/ 
Hardinge HNC lathe,
Bridgeport mill conversion, doing XY now,
Zubal lathe conversion pending
Craftsman AA 109 restoration)


-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to