You need an entry in the Ini file specifying which file editor AXIS should open.
Look at your other config, I'm sure you'll notice it (it's probably EDITOR = gedit, or something like that) Regards, Alex ----- Original Message ----- From: "Ed" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Tuesday, April 01, 2008 4:35 PM Subject: [Emc-users] File Edit got lost! >I used an EMC2 2.2.2 disk to install on my mill and used update to get > it to 2.2.3 and the file edit works great. Using the same disk to update > my shaper from an ancient EMC1 BDI then updating it to 2.2.4, file edit > in the drop down is grayed out along with edit tool table both of which > I use a lot. Is this something that I did wrong or maybe this is a > backgrade because of a proble. In any case I do apprieciate all the good > that has been done with EMC, thanks again. Ed. > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
