To learn the machine control side you can install EMC2 and run it in the sim mode. As for software to train you on how to make chips AFAIK there is not any. General speed and feed guides abound on the internet.
What is the motivation for this? Are you building a CNC lathe etc? John On 4 Apr 2008 at 0:47, Andrew McCallum wrote: > > To whom it may concern. > > Does anybody know where i can get practical training on CNC lathe,or > is there any training software that i cun run from my computer. I am > based in Brisbane Australia. > > Regards > > Andrew ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
