Actually am having similar problems with mach but not as pronounced Aaron > ----- Original Message ----- > From: "John Thornton" <[EMAIL PROTECTED]> > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Subject: Re: [Emc-users] Micro stepper driver MSD542 / KL-5042 cont. > Date: Wed, 21 May 2008 17:38:54 -0600 > > > They came out fine. I see your using a center pull on the Y, novel > idea. Keep in your > mind that the Y motor sees a substantial load compared to the X as > it it carrying the > weight and drag of both. > > Do you know the timing settings you used in Mach? > > John > > On 21 May 2008 at 21:43, aaron Moore wrote: > > > Thanks for you interest everyone. I have tried to post images > > here http://s297.photobucket.com/albums/mm226/Skinnybottom/ > > Cheers Aaron > > > > -- Powered by Outblaze > > > > ---------------------------------------------------------------------- > > --- This SF.net email is sponsored by: Microsoft Defy all challenges. > > Microsoft(R) Visual Studio 2008. > > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > > _______________________________________________ Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
> -- Powered by Outblaze ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
