Thanks Ed, I could not find it so I created this page
http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Example_G-Code_Programs John On 29 May 2008 at 7:37, Ed wrote: > John Thornton wrote: > > Ed, Nice work. Do you mind if I post your code on the wiki site? > > > > Thanks > > John > > Go ahead if you like but I think the skeleton of it was already > cribbed fron the wiki!!! ;-) .Ed. > > ---------------------------------------------------------------------- > --- This SF.net email is sponsored by: Microsoft Defy all challenges. > Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
