I picked up a cheap ($10) unit from the local computer store - I think they have dual port cards and I can already see I'm going to be adding more signals than my PCI slots will allow with single port cards so I'll probably go back. Just about any card should work - the wiki explains finding the address (lspci -v) of the card to use with your setup files just picking which addresses are required to input for the card are kind of confusing (I had to input 2 of the 3 addresses it spat out with the above command). It might take a little experimenting but with halscope it's not hard to check the whole port.
HTH Greg Michalski -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ed Sent: Friday, June 06, 2008 7:33 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Parallel port PCI card aaron Moore wrote: > Hi > > Can anyone tell me what kind of parallel port pci card I need to connect > my computer to the breakout board. I have one computer with no parallel > port and another computer with a parallel port that does not give out > the right signals I presume. I need to get one of them to work. > > Thanks > > Aaron Check at dalco.com for a 2 port card. That is the one I am useing, ordering another one today. Ed. ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users