If you had to take it would still be worth it because nobody makes spindles
as good as the one in that HNC -Maybe the control would fall off the
truck on the way home if you were lucky
Terry
On Thu Jun 26 21:00 , Jon Elson <[EMAIL PROTECTED]>sent:
Kirk Wallace wrote:
> On Thu, 2008-06-26 at 11:09 -0500, Jon Elson wrote:
>
>>Kirk Wallace wrote:
>>
>>>http://cgi.ebay.com/ws/eBayISAPI.dll\?ViewItem&item=330246010908
>>>
>>
>>Will they MAKE you take the GE 550 control? If so, you'll have
>>to dispose of that clunker. I don't believe there's anything
>>there that would be usable.
>>
>>Jon
>
>
> I reused the servo power supply. There are other higher(ish) current
> supplies that might be good for something else. Whenever I need a piece
> of wire, screw, switch, etc. I visit the 550. It's like having my own
> little RadioShack.
>
My WHOLE basement is like a Radio Shack, only FAR better! I
guess if you don't already have such an archive of goodies, it
might be of use.
Jon
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
---- Msg sent via CableONE.net MyMail - http://www.cableone.net
------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
