I am using CamBam and it's output seems to work fine with EMC2. Andy
aaron Moore wrote: > Hi All > > This is a thank you to everyone out there who has helped over the last few > months to get my little stepper powered router going. I > am finally getting some useful stuff done now, and I can do pretty much > everything within Linux....Brilliant. > > I have however acquired some rather good windows software, but its long list > of post processors does not include EMC (shame). Is > there a generic/popular alternative that will work? > > Thanks again > > Aaron > > > -- Andy PGP Key ID: 0xDC1B5864 ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users