"+" moves the Z axis down (into the piece) and the "-" moves the piece up, away from the work.
Ian W. Wright <[EMAIL PROTECTED]> wrote : > John, > First thing you must do is to confirm that your Z axis moves positive > for up and negative for down. Jog it to a position well above the work > surface, Touch Off or Home to zero it, and then in MDI (hit F5 to get > there) type in G1 Z-0.5 F1 or something similar. If the axis goes up > instead of down you need to reverse it which you can do in the settings > to the output pin on the parallel port. > > -- > Best wishes, > > Ian > ____________ > Ian W. Wright > Sheffield UK > > "The difference between theory and practice is much smaller in theory than in > practice..." > > > ------------------------------------------------------------------------- > This SF.Net email is sponsored by the Moblin Your Move Developer's challenge > Build the coolest Linux based applications with Moblin SDK & win great > prizes > Grand prize is a trip for two to an Open Source event anywhere in the world > http://moblin-contest.org/redirect.php?banner_id=100&url=/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
