good idea Jon I will try that although the program doesn't just move to the end of the g2 line - it skips the g2 line completely and move directly to the end of the g1 line that follows the g2 line
On Sat, Dec 6, 2008 at 12:32 PM, Jon Elson <[EMAIL PROTECTED]> wrote: > Stuart Stevenson wrote: >> when the machine enters this state it will repeat the incorrect behavior >> >> > Maybe you need to find out what programs and operating steps your > operator was doing before the problem happened. Perhaps running the > same programs in sequence will cause it to get in the same state. I'm > thinking some sequence of modal commands has got something set in a > really wierd way. I can't think of any logical modal settings that > would do this. Oh, wait a minute! What about the arc plane? What > would EMC do if you set the arc plane to something OTHER than XY and > then give a G02 move with XYIJ words? Is that an error condition, or > does it blithely move to the commanded XY end position, but with no arc, > as the arc is going to be performed in, say, the XZ plane? I don't see > any G17, G18 or G19 in junk.txt to set the arc plane to a known state. > Could be easy to enter the wrong one by accident in MDI. > > Well, there are only 3 arc planes to run the code in, might be worth a > try in the two non-XY planes to see what it does. > > Jon > > ------------------------------------------------------------------------------ > SF.Net email is Sponsored by MIX09, March 18-20, 2009 in Las Vegas, Nevada. > The future of the web can't happen without you. Join us at MIX09 to help > pave the way to the Next Web now. Learn more and register at > http://ad.doubleclick.net/clk;208669438;13503038;i?http://2009.visitmix.com/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ SF.Net email is Sponsored by MIX09, March 18-20, 2009 in Las Vegas, Nevada. The future of the web can't happen without you. Join us at MIX09 to help pave the way to the Next Web now. Learn more and register at http://ad.doubleclick.net/clk;208669438;13503038;i?http://2009.visitmix.com/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
