No problem, i'll try 2.2.8 but... was the same about 2.2.7... i was
using 2.2.6 and you told about going to 2.2.7, and i went, so... should
i guess 2.2.7 is not ready...¿?
I mean... if it is supposed to work in a version, why should i always go
next version to make at least a try?. and this since the first i tryed.
El 19/12/2008 11:30 p.m., Peter C. Wallace escribió:
> On Tue, 16 Dec 2008, Richard Acosta wrote:
>
>
>>> Did sc7i43P report that the 7I43 had a 400K FPGA?
>>>
>>>
>> Yes it says a 400k
>>
>>> Well it should say something like:
>>>
>>> Pass: 1 Error Count: 0 loop count: 100000
>>> Pass: 2 Error Count: 0 loop count: 200000
>>> Pass: 3 Error Count: 0 loop count: 300000
>>>
>> and i confirm this too.
>>
>
> Have you tried upgrading to 2.2.8?
>
> I just did this on a test machine here (motherboard parallel port @ 0x378,
> 7I43-4 connected), started emc, (absolutely stock, no changes) doubleclicked
> on the hm2servo sample config (from Ted Hyde) and I was up and running (well
> I
> dont have machine attached but I did end up with a Axis being a nice 3d
> Etch-A-Sketch when I turned the motor shafts.
>
> Thanks Sebastian!
>
> Peter Wallace
> Mesa Electronics
>
> (\__/)
> (='.'=) This is Bunny. Copy and paste bunny into your
> (")_(") signature to help him gain world domination.
>
>
> ------------------------------------------------------------------------------
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
