I'm getting a "joint following error on axis 0" EMC2 2.3 lately. This usually happens when doing some fine detail an engraving with a fine v bit - and of course when it's about 90% done with the program.. I haven't been doing this long enough to say that it's definitely 2.3 as I didn't get my engraving programs set up until after I upgraded.
What causes this type of error? - Michael ------------------------------------------------------------------------------ The NEW KODAK i700 Series Scanners deliver under ANY circumstances! Your production scanning environment may not be a perfect world - but thanks to Kodak, there's a perfect scanner to get the job done! With the NEW KODAK i700 Series Scanner you'll get full speed at 300 dpi even with all image processing features enabled. http://p.sf.net/sfu/kodak-com _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
