> From: Andy Pugh <a...@an...> - 2009-06-12 16:38 >> >> 2009/6/12 Eric H. Johnson <ejohn...@ca...>: >> It is my understanding that a rapid move (G0) should fully >> complete before a >> subsequent motion command will start. In this case I am doing two >> successive >> G0 moves, where in very rare occasions, > > I don't think that is necessarily true. Look at > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TrajectoryControl > > Or, if you really want to visit every point, use G61. > > -- > atp > > I understand the blending on cutting moves, but on G0 it sounds particularly dangerous. If someone planned their G0 moves to miss clamps or the like, having them blended could be dangerous.
Alan --- Alan Condit 1085 Tierra Ct. Woodburn, OR 97071 Email -- acon...@ipns.com Home-Office (503) 982-0906 ------------------------------------------------------------------------------ Crystal Reports - New Free Runtime and 30 Day Trial Check out the new simplified licensing option that enables unlimited royalty-free distribution of the report engine for externally facing server and web deployment. http://p.sf.net/sfu/businessobjects _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
