Look at: http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TroubleShooting#On_board_video
Regards, Alex ----- Original Message ----- From: "pola ali" <[email protected]> To: <[email protected]> Sent: Saturday, July 25, 2009 2:21 PM Subject: [Emc-users] about latency test > hi everyone > i run latency test . i found this result MAX jitter for servo thread > nearly 400,000 NS and MAX jitter for Base thread nearly 160,000 NS. > which is not good rate , i would be grateful if anyone tell me how reduce > this rate . > the PC i run ubuntu 8.04 on it is Pentium 3 , ram 512 MB . > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.392 / Virus Database: 270.13.29/2261 - Release Date: 07/25/09 05:58:00 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
