Have an e.d.m. It has a small servo with a pot attached to it.There are 6 leads on the servo, but just 3 wires running to it. All 6 post on the servo has wires.
I have not traced it out yet.
It runs for a few moments and then stops. I put new bearing in it and it turns great.
The servo is a Japan Servo ESA-1N-S 1.0 W 100/100 volt 50/60 hz 2p 1.5/1.2 uf AE19042 How can I run a check on the servo? Does anyone know of a replacement? Could the pot be bad?I know this is a E.M.C. q&a but I have been reading for while and it seems you folks have a lot of knowledge.
Thank all of you in advance. Jeff
<<attachment: alpha_mach.vcf>>
------------------------------------------------------------------------------ Come build with us! The BlackBerry(R) Developer Conference in SF, CA is the only developer event you need to attend this year. Jumpstart your developing skills, take BlackBerry mobile applications to market and stay ahead of the curve. Join us from November 9 - 12, 2009. Register now! http://p.sf.net/sfu/devconference
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
