Hello Jon, 0,5 millisecs is quite good. I was asking because I could get the Oxford PCI840 to just about 10ms servo cycle time before the driver would cause an error.
Cheers Max > Maximilian H wrote: >> Hello Everybody, >> >> I was wondering which is a reliable setting for a servo cycle time with >> an extra pci parallel card, assuming that the whole setup works "as it >> should" ? >> >> I have been using a 1 millisec servo cycle time with onboard motherboard >> parallel ports, but with extra pci parallel port cards I have no >> experience so far. >> > The PCI parallel port should be a little faster, I'm sure you could go > to 0.5 ms and > probably even higher. I'm not sure whether this will be any advantage, > though. > > Jon > > ------------------------------------------------------------------------------ > Join us December 9, 2009 for the Red Hat Virtual Experience, > a free event focused on virtualization and cloud computing. > Attend in-depth sessions from your desk. Your couch. Anywhere. > http://p.sf.net/sfu/redhat-sfdev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Join us December 9, 2009 for the Red Hat Virtual Experience, a free event focused on virtualization and cloud computing. Attend in-depth sessions from your desk. Your couch. Anywhere. http://p.sf.net/sfu/redhat-sfdev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
