Thanks John,
Works like a charm with the "P" added. I must have misread the
docs. Thanks for your help!
Paul
----- Original Message -----
From: "John Kasunich" <[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Sent: Wednesday, June 02, 2010 9:57 PM
Subject: Re: [Emc-users] M64 and M65
>
>
> On Wed, 02 Jun 2010 20:46 -0400, "Paul Keeton" <[email protected]>
> wrote:
>> Steve,
>>
>> I was just issuing the command in MDI. (M64 then enter)
>
> You should probably be doing something like "M64 P2" then enter.
> The P word specifies which output you want to control. If
> you don't specify a P word it is anybody's guess as to what
> value will be used. From the error messages, it looks like
> EMC is using 255 as the value. Since M62 thru M65 support
> only four outputs by default (0 thru 3), using 255 (or any
> number higher than 3) will give that error message.
>
> See the documentation for those M-codes at:
> http://linuxcnc.org/docs/html/gcode_main.html#sec:M62-to-M65
>
>
> John Kasunich
> --
> John Kasunich
> [email protected]
>
>
> ------------------------------------------------------------------------------
> ThinkGeek and WIRED's GeekDad team up for the Ultimate
> GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the
> lucky parental unit. See the prize list and enter to win:
> http://p.sf.net/sfu/thinkgeek-promo
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the
lucky parental unit. See the prize list and enter to win:
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
