These bolt holes are used for mounting large face mills. They use a centering plug in the taper but do not rely on a drawbar to hold them into the spindle. The plug is not a permanent part of the face mill, but rather an accessory used with an other face mills.
> -----Original Message----- > From: Andy Pugh [mailto:[email protected]] > Sent: Wednesday, June 30, 2010 10:03 AM > To: Enhanced Machine Controller (EMC) > Subject: [Emc-users] Spindle Noses > > My milling machine has 4 M10 holes on the face of the > spindle. (It is a 30 INT). it appears that these are part of > the specification for 30INT. Has does anyone know what they are for? > > http://i200.photobucket.com/albums/aa294/oldtiffie/machine_tap > ers/Machine-taper5.jpg > > -- > atp > > -------------------------------------------------------------- > ---------------- > This SF.net email is sponsored by Sprint What will you do > first with EVO, the first 4G phone? > Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net email is sponsored by Sprint What will you do first with EVO, the first 4G phone? Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
