- Igor
On Wed, Sep 1, 2010 at 1:59 PM, rng3 <[email protected]> wrote: > Hello, > > You might want to look > here..http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Simple_Remote_Pendant > John has set this up with 3 proportional jog speeds . > Rick, thanks a lot. It looks like it is close to what I may want to do. i > Rick G > >> Hi Guys. I have a Saitek P800 joypad configured as a mill control. It >> is awesome. >> >> It has one parameter pre-set: >> >> setp halui.jog-speed 30 # desired maximum jog speed mm/min >> >> Then I have a few buttons configured for jogging: >> >> net velX input.0.abs-rz-position => joyhandle.0.in >> net velXout joyhandle.0.out => halui.jog.0.analog >> net velY input.0.abs-z-position => joyhandle.1.in >> net velYout joyhandle.1.out => halui.jog.1.analog >> net velZ input.0.abs-y-position => joyhandle.2.in >> net velZout joyhandle.2.out => halui.jog.2.analog >> >> >> And I have some buttons configured for misc stuff: >> >> >> # Flood on and off buttons 1 and 2 >> net floodOff input.0.btn-thumb2 => halui.flood.on >> net floodOn input.0.btn-trigger => halui.flood.off >> >> and so on. >> >> What I want to do is to change the default jog speed from the joypad. >> Somehow I want two buttons, one for decreasing halui.jog-speed and one >> for increasing. Say I have them called example1 and example2 buttons. >> >> Could I say something like >> >> net increaseJog input.0.btn-example1 => halui.jog-speed.increase >> net increaseJog input.0.btn-example2 => halui.jog-speed.decrease >> >> Clearly my syntax is wrong, but is there some way of changing max jog >> speed from the joypad itself? >> >> Thanks a lot. I am loving every minute of using EMC2. >> >> i >> >> ------------------------------------------------------------------------------ >> This SF.net Dev2Dev email is sponsored by: >> >> Show off your parallel programming skills. >> Enter the Intel(R) Threading Challenge 2010. >> http://p.sf.net/sfu/intel-thread-sfd >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
