A few things to look at - My inital hookup of the amc drives to the mesa hardware was wrong. ( I had just hooked +/- up to the drive with the shield hooked to ground.)
I did some searching and found this http://www.a-m-c.com/download/document/support/general/instnotes.pdf Look at section 3.1 - I used the wiring examples there. The thing smoothed out. Also - this goes into tuning http://www.a-m-c.com/download/document/support/analog/tuning_procedure.pdf On 9/14/2010 8:34 AM, Igor Chudov wrote: > Guys, honest, I did look for explanations and did not find enough. > > Could someone explain what are FF0, FF1 and FF2 parameters pertaining > to tuning a servo loop? > > Thanks > > - Igor > > ------------------------------------------------------------------------------ > Start uncovering the many advantages of virtual appliances > and start using them to simplify application deployment and > accelerate your shift to cloud computing. > http://p.sf.net/sfu/novell-sfdev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Start uncovering the many advantages of virtual appliances and start using them to simplify application deployment and accelerate your shift to cloud computing. http://p.sf.net/sfu/novell-sfdev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
