Oops, I found something, section 1.1.2 (Pins) of http://linuxcnc.org/docs/html/config_emc2hal.html
Thanks On Thu, Nov 25, 2010 at 10:01 PM, Igor Chudov <[email protected]> wrote: > I would like to finalize wiring a rotary indexer. I mentioned it here > previously, it is a Haas 5C rotary indexer with a "remote button", > such that if you press it by hand, the indexer gets a signal and > advanced by the predefined angle. > > I believe that the sequence of > > M64 P1 > G4 P0.25 > M65 P1 > > would do it simulating a "button press" lasting 0.25 seconds on the > digital output 1. I would use Jon's DC SSR to switch on and off. > > What I am not sure is, how do I link M64 and pin number P to digital > outputs? Where do I tell EMC that M64 P1 corresponds to digital output > number 7, for example? > > Thank you for clarifying my post-Thanksgiving confusion. > > i > ------------------------------------------------------------------------------ Increase Visibility of Your 3D Game App & Earn a Chance To Win $500! Tap into the largest installed PC base & get more eyes on your game by optimizing for Intel(R) Graphics Technology. Get started today with the Intel(R) Software Partner Program. Five $500 cash prizes are up for grabs. http://p.sf.net/sfu/intelisp-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
