On Fri, Dec 10, 2010 at 09:51:45AM +0000, Steve Blackmore wrote: > On Thu, 9 Dec 2010 21:00:33 -0600, you wrote: > > >Touchy has had lathe support for a while now, but I'm not using it > >yet. Have you tried it? > > Hi Chris > > No, couple of things with it. > > No backplot and DRO's too small to read at distance.
You know you can pick any size you want? See the prefs tab. > Don't know how I could run my machine in Sim. What happens is press > spindle start, that enables spindle and seems to enable PWM output to > VFD at 50% duty rate. Press + and PWM then drops to 0%, then you need to > press + again to control speed. > > It does it even if you have previously set a speed on the MDI screen, > and ignores a speed set in RS274NGC_STARTUP_CODE > > It should start at 0% PWM or S0 if you have not set a speed, or at a > speed set in startup code. Talking about PWM is missing my point - maybe I didn't explain enough. Any PWM you have is a function of your HAL setup. What I'm asking whether you can do is run a sim configuration and cause EMC to give an incorrect output on one of the motion.spindle-* pins. Then describe on the list how someone else (me) can cause that to happen and observe it too. The idea is we use sim (which we all have) as a way for you to show the reported problem, separate from your machinery and any HAL setup you've done (which only you have). ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
