Hi, I made a similar experience with the defined axis x,y,u and v for a hotwire foam cutter. It only concerns the displayed picture. It's quite difficult to explain what is wron. A picture would tell every thing, if somebody is interested.
The actual cutter runs fine and precise thanks to the great effort of the EMC2 team. Thanks al lot for your work!! Best regards Peter Georgi -----Ursprüngliche Nachricht----- Von: Lars Levin [mailto:[email protected]] Gesendet: Samstag, 12. Februar 2011 14:32 An: [email protected] Betreff: [Emc-users] AXIS showing path wrong Hello Goup! I have a gantry mill setup and running with a custimised 5-axis kins. joints as: X Y Z X2 B C Y2 Z2 W When I load a gcode file the window shows the max XYZ dimensions and tool as it should, but the 3d curves from the code are flattened to the xy plane and also seems to be twice the length in x than it should. When running the code the machine runs as it should. Any ideas what could be the cause of this? Best Regards! Lars Levin -------------------------------------------------- ---------------------------- The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-u sers ------------------------------------------------------------------------------ The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE: Pinpoint memory and threading errors before they happen. Find and fix more than 250 security defects in the development cycle. Locate bottlenecks in serial and parallel code that limit performance. http://p.sf.net/sfu/intel-dev2devfeb _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
