Kent suggested I add some information about stepper motor speed
limitations to the wiki. I tend to never finish anything because it's
never good enough. This isn't good enough, but it's up there.
It's titled:
* Stepper Motor Speed Limitations
<http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Stepper_Motor_Speed_Limitations>
You can point out whatever isn't very clear. I'd like to make it better
than it is, but I'm going to take a breather before I do any major edits.
Thanks for any comments.
------------------------------------------------------------------------------
The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE:
Pinpoint memory and threading errors before they happen.
Find and fix more than 250 security defects in the development cycle.
Locate bottlenecks in serial and parallel code that limit performance.
http://p.sf.net/sfu/intel-dev2devfeb
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
