Hi all; I just downloaded and installed the mdv rpm on this pclos box, and the rpm went it except for the k-menu additions, so I have to run it from a user terminal session until I figure out how to edit the kmenu's on pclos.
Has anyone else played with it yet? I ran it, selected 'new' as it said in the help, then went to the next section to try and setup a properly scaled & gridded view port for the next project, in this case the 8 sticks it will take to make 2 overlapping at the center doors for this cabinet I'm building. Unforch, nothing in the Properties column on the left appears to be editable, so its not possible to proceed further using known dimensions for the snap to grid etc etc. I'm a dummy I guess. This thing isn't in english as its first language, so some of the terms I see in the help file are probably going to need some explaining here and there. I did finally get it to take a filename in the first box, but when I continue to adjust other things, the filename disappears and when I get frustrated and quit, the project is still called NO_NAME.dwg. I think I need to start from square one. But, before I put a lot of effort into this, is there such a thing as a .dwg to .ngc converter? Thanks everybody. -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) <http://tinyurl.com/ddg5bz> <http://www.cantrip.org/gatto.html> It is impossible to travel faster than light, and certainly not desirable, as one's hat keeps blowing off. -- Woody Allen ------------------------------------------------------------------------------ Colocation vs. Managed Hosting A question and answer guide to determining the best fit for your organization - today and in the future. http://p.sf.net/sfu/internap-sfd2d _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
