2011/7/6 Dave <[email protected]>: > On 7/5/2011 5:26 PM, Andrew wrote: >> 2011/7/6 andy pugh<[email protected]>: >> >>> On 5 July 2011 20:56, Andrew<[email protected]> wrote: >>> >>> >>>> My D525MW shows up to 18000 with 2 glxgears running for several hours. >>>> Even base period 35000 results in realtime delay message (with 3000 ns >>>> driver timings). I'm very disappointed. >>>> >>> Do you have isolcpus set? That might help. My D510 actually gives RT >>> errors with the video camera plugged in (psha reports no problems >>> though) >>> >> Yes, I forgot to mention... isolcpus=1 and HT = off. Based on all >> feedbacks I expected less than 7500, maybe 10000, but 18000 is too >> much. Just can't understand what's the problem. Actually it will be >> used with 7i43, latency is not that significant, but it is still >> strange. >> >> Andrew >> >> > > Andrew, > > Any chance you have a D510 board lying around that you can plug that > hard drive into to see if you get the same results on a D510 board? > > I know this sounds odd but this usually works (swapping drives between > different Atom boards). > > How did you get the software set that you are using? Did you install > off the CD or ?? > Dave, no other boards around. I use CF to SATA converter, it might be a problem. I installed from the flash drive, but forgot to check the latency bofore installing. And now after BIOS update (which corrected reboot and other issues) I can't load from that flash. I could try to install EMC2 on a hard drive, but it makes no sense - I won't use it anyway.
Andrew ------------------------------------------------------------------------------ All of the data generated in your IT infrastructure is seriously valuable. Why? It contains a definitive record of application performance, security threats, fraudulent activity, and more. Splunk takes this data and makes sense of it. IT sense. And common sense. http://p.sf.net/sfu/splunk-d2d-c2 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
