Helping Dan Field with a question on setting up the Tool table (in another forum).
He is using the tool offset commands and cutting with a 60 degree v bit. Does the tool table care if its a v bit or just the overall diameter? http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?ToolTable The wiki does not seem to address whether is a end, ball or v mill. My gantry is down right now so I can't check it out on my machine. Brian ------------------------------------------------------------------------------ Using storage to extend the benefits of virtualization and iSCSI Virtualization increases hardware utilization and delivers a new level of agility. Learn what those decisions are and how to modernize your storage and backup environments for virtualization. http://www.accelacomm.com/jaw/sfnl/114/51434361/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
