I think that is the problem.... so simple On the HAAS Lathe I do not have to set the G43 - it is automatic..... I am going to give that a try.
Thanks On Wed, Oct 12, 2011 at 1:08 PM, Chris Radek <ch...@timeguy.com> wrote: > On Wed, Oct 12, 2011 at 12:34:14PM -0600, Brian May wrote: > > If I set T1 and T2, then in MDI type T1 M6 - I am > > thinking that the position should change... from the T2 position. > > Are you just forgetting to invoke G43? > > > > ------------------------------------------------------------------------------ > All the data continuously generated in your IT infrastructure contains a > definitive record of customers, application performance, security > threats, fraudulent activity and more. Splunk takes this data and makes > sense of it. Business sense. IT sense. Common sense. > http://p.sf.net/sfu/splunk-d2d-oct > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Brian May 506.8862.9162 (Cell) 506.2293.6375 (Office) ------------------------------------------------------------------------------ All the data continuously generated in your IT infrastructure contains a definitive record of customers, application performance, security threats, fraudulent activity and more. Splunk takes this data and makes sense of it. Business sense. IT sense. Common sense. http://p.sf.net/sfu/splunk-d2d-oct _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
